Well first of all..
You want heat in your house when it's cold, RIGHT? So you turn on the heater with the knob.. and the heat comes out of the vents. No vents = explosion.
And basically.. no vents as I said.. explosion, because the gas has nowhere to go so the pressure will build up and BOOM.. flames.
Yes you can get a high wind cap for the vent.
gas gets trapped in the drainage system if you don't vent it (and you don't want that gas coming back into the bathroom)
to bleed the air out of the system
A stack vent is is the extension of a soil or waste stack above the highest horizontal drain connected to the plumbing stack Vent stack a vertical vent pipe extending through more then two stories which is then connected to a stck vent or is otherwise extended throgh the roof, installed primarily for the purpose of providing circulation of air to and away from any part of the drainage system
Bleed or Weep Holes are located at the elevational top or bottom of the Orifice Plate. The Weep Hole is tangent to a circle equal to 98% of the line I.D. DRAIN HOLES are located at the bottom of the Orifice Plate to prevent liquids in a gas or condensate in a steam flow from damming up behind the Orifice Plate. VENT HOLES are located at the top of the Orifice Plate to allow gases in a liquid flow to vent pass the Orifice Plate.
The purpose of the vent on the furnace is to ventilate flue gases out side of the house.
The purpose of the vent on the furnace is to ventilate flue gases out side of the house.
The purpose of the vent on the furnace is to ventilate flue gases out side of the house.
The purpose of air vent on pipe works of infrastrucure
A gas vent would be above the level of a liquid; it would allow gas to escape as the liquid rises or air to be drawn in as the liquid lowers in attempt to equalize gas and atmospheric pressure. A vent located below the liquid line would allow the liquid to escape as the liquid level in the enclosed area rises.
Vent covers are manufactured in many different sizes to be able to fit all vents. The purpose of a vent cover is to protect a vent from allowing rain to enter, while still allowing air to circulate.
If it is in good condition, it can be left alone. If it is deteriorating, it should be removed.
YES
Yes you can get a high wind cap for the vent.
The vent is located under the tail feathers. The vent is a dual purpose orifice for waste removal and egg laying.
The same way you would vent an electric model. Just connect the vent pipe.
B-vent pipe.