answersLogoWhite

0

http://wiki.answers.com/Q/What_is_the_push-rod_placement_for_a_1996_lumina_3.1_engine Look at the rocker arm stands,some are higher then the others where they bolt down to the head.The longer rods go to the higher mounted rockers.

User Avatar

Wiki User

16y ago

What else can I help you with?

Related Questions

1997 Chevy Malibu 3.1 push-rod order?

What_is_the_push-rod_placement_for_a_1996_lumina_3.1_engine


Where is the fuel door release on the 2012 Chevy Malibu?

You push the gas door in and it releases.


Where is gas cap release on a 2011 Chevy Malibu?

Push in gas cap door it will release


How do you reset clock on Chevrolet Malibu 2000?

Push and hold the HR or the MIN buttons


How to pull down the backseat in a 2001 Chevy Malibu?

pull the strap in the trunk then push the seat down


Ignition in a 2000 Chevy Malibu?

remove instrument cluster, remove 2 screws holding switch in, push switch about 1 inch straight back to clear mounting bracket. pull straight out.


How do you use remote start Chevy Malibu 2008?

Push the lock button ,then the top button for 2-3 seconds.


Where is the emergency brake release located on a 2010 Chevy Malibu?

The emergency brake release on a 2010 Chevy Malibu is located beside your left foot. You would push down on the emergency brake pedal to release it while having your right foot on the regular brake.


2000 Malibu it run but when you push gas it dies What is wrong?

check fuel filter,sounds like your not getting fuel,


Your driver side window switch will roll the window down but will not roll it back up on a 2000 Chevy Malibu?

I'm having the same problem with my 2000 Chevy Malibu. I took the switch apart, noticing that the plastic piece that rocks back & forth on the middle of the base, that seperates the contacts has melted. I used the end of a q-tip minus the cotton to push the contacts down for the up position. The window went up. I'm going to replace the swith.


How do you install an ignition switch on a 2000 Chevy Malibu?

disconnect negative battery cable.remove instrument cluster,remove 2 screws holding switch in. push the switch about an inch straight back to clear the mounting bracket,then lift it up and out of panel..


How do you retract the break pump to put over the breaks on a 2004 Chevy Malibu?

Assuming you have the floor pedal type, you push it down farther and it releases and comes back up. Ie. push it once to lock it, push it again to release it.