I'm having the same problem with my 2000 Chevy Malibu. I took the switch apart, noticing that the plastic piece that rocks back & forth on the middle of the base, that seperates the contacts has melted. I used the end of a q-tip minus the cotton to push the contacts down for the up position. The window went up. I'm going to replace the swith.
I also have a 2002 Chevy Malibu that had the weird blinker issue. Last year I checked it out and found it was a recall. You should be able to have it fixed for free. Mine was fixed last spring and I haven't had any problem since.
The oxygen sensors in a 2005 Chevy Malibu are in the exhaust system. You'll find them at the end of the down pipes and behind the catalytic converter.
its a Honda NSX, not sure the year
Just had my turn signal switch replaced, for the second time, on my '98 Chevy Lumina. I paid $260 to a fairly trustworthy auto repair mechanic
Just because I had one in the past (2004 malibu) I would say that I has something to do with the fuse that works for the turn signal and brake light. Because for them both not to be working I would doubt that it was a bulb. Just my opinion. Of course you should get it looked at.
window make a noise, but won't roll down
1998 chevy malibu programe new switch
how do you check the safety neutral switch on a 2003 Chevy Malibu
How do you replace vent windowin a 2005 chevy malibu?
It is not possible to replace single switch in the driver side window cluster of Ê2000 Chevy Tracker. The cluster is only sold as one piece and single switches cannot be purchased.
How to replace a window and regulator on a 1998 checy malibu?
Yes. '97-'05 the same.
04 Malibu fuel shut off switch location
take the door panel off & power up the motor directly with jumper wires. if this won't work the motor is probably not working & will need to be replaced.
you should be able to take the cover off the driver's door by unscrewing it,then unplug the window switch and replace it,fairly easy..
it could be your window switch..try changing it
assuming itis the switch and not the motor remove switch n hot wiretillup or use switch out of other side.....