"ReLay" as for an external Re-Lay
The solenoid is on the starter.
The starter relay on a 1999 GMC Suburban with the bib block engine is located on the solenoid for the starter. The solenoid for the starter is on top of the starter.
Starter solenoid? One top of starter--follow + battery cable
The starter location on a 2002 GMC Envoy is on the passenger side of the engine compartment. It is just below the manifold. Both the starter and starter solenoid are located here.
Your starter solenoid is the ropund part attached to the top of your starter it has the little wire to trigger the starter drive to engage the flexplate and a big battery wire to spin it hope this answers you question
Flat battery or sticky starter motor / solenoid - try re-charging battery or get a jump start Flat battery or sticky starter motor / solenoid - try re-charging battery or get a jump start
Sure you could replace it or rebuild it, but you're better off buying a new starter and getting the core fee back ;)
On top of the starter. Disconnect the negative ground to the battery, get under and pull the two starter bolts, back the starter out of the bellhousing to get to the two wires on the solenoid. Be careful: the starter is heavy, and will swing toward the pan rail on the engine block. It takes a year for a thumbnail to grow back.
On the engine near the starter. It is accessible by removing the driver side front wheel and inner skirt.
Replace Remove starter Remove solenoid at top of starter Remove front end of starter for access Remove locking washer from starter shaft Drive should slide off shaft
the starter GMC Yukon?
The fusable link should be located at the starter connection on the solenoid. Where the main positive cable hooks to the starter solenoid there should also be a smaller wire connected on the same terminal. The smaller wire will be the fusable link. Make sure to disconnect the battery before attempting to remove the nut from the solenoid terminal.