Need to specify an exact model.
I was told that it is the temp sensor. The car needs to be at 150 degrees. I am working on the same problem.
Check the diameter and circumference of the flywheel for each transmission. IF they match, then the flywheel will fit.
Check either: Solenoid, Wiring, Switch, or OD Relay.
To fill the transmission fluid in a 1986 Oldsmobile Regency, locate the transmission dipstick tube, which is usually found near the back of the engine compartment. Remove the dipstick and use a funnel to add the appropriate type of transmission fluid through the tube. Be sure to check the fluid level with the engine running and the transmission in "Park" to ensure accurate measurement. Always refer to the owner's manual for the correct fluid type and specifications.
Maximum Overdrive was created on 1986-07-25.
yes
Will not bolt up and is not strong enough for the 3800.
what is the ratio of gears in a 1986 cutlass
you remove the small plastic overdrive tab on the top of the shifter,it should pop off using a small flat head screwdriver, then unscrew the t bar that goes to the overdrive switch, count the turns. Then unscrew the shift knob.
not unless you can change the bell housing! the 2.9 and 3.0 have different bolt patterns. GOOD LUCK!
In the fuel tank. It is replaced by removing the fuel tank then extracting it from the top.
Yes