Want this question answered?
.030
1ml
SAE 30
Run the car good
On a horizontal crankshaft engine it is done by loosening the pinch bolt and rotating the shaft in a clockwise direction with the throttle in the high speed position and retightening
You loosen the nut own the governor arm turn the arm clockwise and then turn the governor shaft clock wise. Tighten nut That should do it.
All the small Briggs engines seem to have a points gap of 0.02 inches
any where from 120 lbs to 180 lbs
A Champion CJ8Y or J19LM will perform fine
The spark plug should be gaped at .030"(76mm)
0.030" for a champion or 0.020" for NGK and others.
It may be one of two things. Either it isn't getting enough gas, or to much