answersLogoWhite

0


Best Answer

32mm

User Avatar

Wiki User

11y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: What is the size of hub nut on 1986 Honda Accord?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

What size socket is required to remove the hub nut on 2006 Honda Accord se?

36mm.


What is the size of a 1996 Honda civic lx hub nut?

32mm. is the hub nut size


Can you install Rear Axle in Honda accord 1998?

98 accord does not have a rear axle- just spindle/hub/bearing


What size hub caps will fit the 1990 Honda Accord stock wheels?

The size of the wheel. 13", 14", 15", etc Look on the tire and it will tell you the size of the wheel as in P205/70-15 That is a 15" wheel.


What is the hub diameter of a 2001 4dr Honda accord ex v6?

Hub Diameter--->64.1......bolt pattern---->5 X 114.3


How do you remove the the external torx bolts that hold the hub that holds the front rotor on for your 91 Honda Accord?

I believe it is a 12 point metric socket Not sure of the size though.


What is the size of a 95 Honda civic hub nut?

32mm


How important is the wheel bearing hub assembly on a Honda Accord year 1994?

It is extremely important. A defecting hub assembly or wheel bearing can cause you to have an accident.


Will 2006 Toyota solara steel wheels fit 2008 Honda accord coupe?

If the bolt patterns are similar then it should but you need to look into the hub size. Toyota are smaller than hondas. If the bolt patterns are similar then it should but you need to look into the hub size. Toyota are smaller than hondas.


What would cause groaning noise when reversing a 1999 Honda Accord EX?

If the Honda Accord makes a groaning noise when reversing the can be caused by bad hub bearings. Hub bearings are what allow the car's wheels to spin, if gone bad they can cause wheels to come fully off the vehicle.


How do you remove 1989 Honda accord hub assembly?

i just recently did this and its not easy lol. you have to completely remove the spindle from the car and press the wheel bearing out along with the hub assembly.


What is the size of a 2000 Honda Accord rear hub nut?

Used a 32 mm socket. After removing the hub nut I re-installed the wheel and tightened the lug nuts and then tapped on the inside of the rim to get the hub off the spindle (didn't have to tap very hard). Also needed a manual impact driver ($25) to break loose the 2 screws holding the brake rotor to the hub.