Want this question answered?
.030 (0.76 mm) gap. Use a Tecumseh resistor plug.
According to the manual, it is 0.030 Robert
Mine has NGK BPMR4A
Most snow blowers have the spark plug on top of the motor :to change a spark plug you get a spark plug wrench (take wire cap off the plug) put wrench on spark plug then turn counter clock wise to take it out. To put a new one back in reverse the proses
http://www.toro.com/home/customercare/interactivemanuals.html Snowthrowers Single Stage Snowthrower TOC Maintenance Spark Plug Conditions Page down to Replacing a Spark Plug
dont know just got mine but it had a champion h10
20 thousands per john deere
You can cross reference a RC12PYP3 or RC12YC non-platinum spark plug for a Briggs 696798. The Briggs Platinum 696798 spark plug is for a snow blower. Part number 696020 for a Platinum plug from Sears is an equivalent also.
I will assume a valve-in-block engine and the answer is an RJ19LM Champion or equivalent.
If a snow blower is not getting gas, there could be a few different problems. The fuel line could be clogged, or the spark plug might have gone bad. There could also be a hole in the fuel line.
13/16" - at least that is the size for my honda 520S snow blower.
.035