What is the spark plug location on a V6?

Answer 1

1) The location of spark plugs 456 are under the plastic shield in front of the engine. It takes an 8mm socket to remove the three bolts holding the shield once the shield is removed you will see a coil for each spark plug. Use the 8mm socket and remove the coil and rubber boots. You will now see the spark plug (note there are not any spark plug wires).

2) The location of spark plugs 123 are located to the rear of the eng. You have to remove the air intake manifold in order to get to the spark plus. Remove the throttle wire then remove the other items on top of the intake manifold.

3) Loosen all the bolts holding the manfold. 8mm socket-- I think three in front and three in the middle. Remove the EGR valve mounts so you can slide the manifold out. Disconnet all vacuum lines from manifold and the air filter inlet closet to manifold. Just take a general look and ensure you have all wiring and tubing disconnected then slide the manifold off the eng and EGR valve.

NOW MAKE SURE you cover all intake holes (leading into the engine) with paper towels to prevent droping screws etc into the engine. Then follow step 1 above ... END

Three located on each head.

i can tell from your answer you have NEVER changed the plugs on a 2.3. probably have never even SEEN them. first off, the front bank is 2-4-6. the rear(right) bank is 1-3-5. and the only 8mm bolts i can think of are the ones holding each coil on, 2 per coil. the plastic "miller cycle" cover is held on by 2 10mm cap nuts. the front intercooler is 12mm. and the right bank plugs are WAY more complicated to get at than that simpleton explanation, plus the intake manifold does NOT have to be removed.