Usually in the centre. Check with brand and model of the shower to be installed for exact measurements or check the rough-in manual for the EXACT shower for proper measurements.
Shower drain goes into a trap under shower. Continue piping from trap to drain line.
the rear passnger side corner of the oil pan
Water won't drain from shower. Either trap or shower drain line is clogged.
The oil drain plug is on the passenger side of the oil pan. It is close to the rear corner of the pan.
Standing in the front of the truck, It will be on the inside of the bottom right corner of the radiator.
YES.
typically shower drains are 2"
A shower rough-in usually refers to the distance from the wall to the center of the shower drain , measured out away from both walls in a shower to the center of the drain. It also maybe referring to the height and the center line of the placement of the shower valve.
on the bottom left corner of the radiator you will find a little hose sticking out and a small on/off nob to drain it
The center of the shower floor where the tile shower drain would normally be positioned ... drain base. After this step the sloped mortar bed should be ... pan liner or membrane in our instructions.
Possibly a caulked joint ( lead and oakum )
This can be a complicated job as the toilet drain ranges from 3" -4" and a variety of materials from Plastic to cast iron to galvanized. Then there is the venting to consider and NO a shower drain CANNOT be used for a toilet discharge as the shower drain is normally 2" diameter