answersLogoWhite

0


Best Answer

16 ft-lbf based on link below (for SOHC)

http://www.saturnfans.com/forums/showthread.php?t=44221

User Avatar

Wiki User

11y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: What is the torque for the exhaust manifold for a 1996 Saturn SL1 1.9?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Where is the b1 oxygen sensor in a 1996 Saturn?

The oxygen sensor on a Saturn can be found in the exhaust manifold at the front of the engine. It simply unscrews and unplugs. 5 minute fix!


Where is the oxygen sensor on a 1996 Saturn SL2?

There is actually two on this car. One is on the exhaust manifold with a single wire under the hood and. One is after the cat under the car


Where is the oxygen sensor on a 1996 Chevy Blazer?

should be on the exhaust manifold


1996 Chevrolet c1500 pickup truck bolt torque specifications for 5.0L intake manifold?

1996 chevy c1500 pick up 305 motor bolt torque spec intake manifold


How do you install cylinder head bolts on a 1996 Saturn?

What are the torque specifications and the tightening sequence of the cylinder head bolts on a 1996 Saturn SL1?


Where is the starter on a 1996 Grand Caravan 3.3 engine?

Front of the engine, just below the exhaust manifold.Front of the engine, just below the exhaust manifold.


Where is the oxygen sensor on a 1996 range rover?

It is located either on the exhaust manifold or on the exhaust pipe before the catalytic converter.


Where is the oxygen sensor on a 1996 Plymouth Voyager and how do you change it?

It is in the exhaust manifold next to the firewall.


1996 Nissan Pathfinder change exhaust manifold?

What engine???????? You should refer to repair manual if not familiar with auto repair and understand the terminology before attempting Remove nuts holding exhaust manifold to cylinder head & remove nuts/bolts holding exhaust manifold to exhaust pipes Use new exhaust manifold gaskets and install the new manifold securing the manifold to cylinder head (may need to but new nuts and or bolts) by "snugly" tightening manifold to cylinder head if not refering to repair manual


Where is the block heater for a 1996 aura integra?

The block heater on a 1996 Aura Integra is located to the left of the exhaust manifold shield. It is also called the exhaust heat shield.


How do you get the head gasket off a 1996 buick regal?

The intake manifold, head, and exhaust manifold must be removed to gain access to the gasket.


How many oxygen sensors on a 1996 Saturn?

Two, One on the exhust manifold and the second after the CAT