The first round is going to be 50-60 foot lbs. the second round is going to be 80-90 foot pounds. The first bolt will be the middle pasenger side three bolts from the front of the engine. The second is the one in the same position on the drivers side. then you go back to the passenger side four bolts from the front, then drivers side two bolts from the front.
65ft. LBS.
The 1999 Ford Ranger 3.0 liter water pump bolt torque specifications are 40 pounds. You do not want to torque the bolts to hard or they will break.
manifold to head bolts 32 ftlbs
For the 1996 Chevy S-10 4.3 liter, the torque specs for the crankshaft damper bolts is 70 ft. lbs. For the cylinder head bolts, the torque is 65 ft. lbs, and for the engine mount-to-head bolts, the torque is 35 ft. lbs. For the engine mount-to-frame bolts, the torque is 52 ft. lbs.
The Chevrolet 2.2 liter engine had bolt torque specification is 120 pounds. The head bolts should be torqued in 40 pound intervals.
On your 1992 Ford Ranger , 4.0 liter : The starter should be on the drivers side of the engine , low down , where the transmission bolts to the rear of the engine
== ==
torque specs on the bolts that hold the rockers on a 4.9 cadillac motor
what is the torque specificationfir the rockerarm bolt on 1991 Buick le Sabre v-6 3.8 liter
For the 4.0, it is 6 foot pounds.
The 1.8 liter engine cylinder head bolt torque setting is 150 pounds. The cylinder head bolts should be torqued in 50 pound intervals.
17 foot pounds on a 3.3 Liter, and 21 ft pounds on a 3.5 Liter