11 nm then 2 x 180 degree turns
According to my Haynes manual, 20Nm. Tighten to this force on the first cycle of bolts (in the correct order) and then half a turn on the next cycle, and then another half a turn on the last cycle.
The cylinder head torque settings for a Land Rover 300 DTI starts at 40Nm for all bolts. Then for M10 x 117 mm long 60 degrees, M12 x 100 mm long 60 degrees.
1. tighten to 20nm. 2. then tighten all an extra 360 degrees.
TD5 Engine rocker torque setting is 10Nm or 7lbft
420i.
Fn T
manual de torque
Engine code K16-1.6 Head torque Stage 1. 20Nm Stage 2. + 180 degrees Stage 3. + 180 degrees.
THis ain't no question
Fn T
40NM initially on all head bolts Then... 60 degrees on all Then another 60 degrees on all Then the M12x140mm bolts are a further 20 degrees
initially you tighten all bost to 28 newton metres then you angle tighten by 90 degrees leave for 5 mins and angle tighten by another 90 degrees this information was supplied to me by a trained rover mechanic i did it on my metro 1.1 on a j reg and it was fine