Want this question answered?
nomnjfjsd
nomnjfjsd
You use a transducer in a wheatstone bridge. The wheatstone bridge allows you to find an unknown resistance.
Ultrasound is the name of the proceedure; a Sonogram is the picture image produced by an ultrasound scan.Therapeutic ultrasoud uses low frequency sound waves to penetrate deep into the injured tissue during rehabilitation. This form of ultrasound creates heat using the lower frequencies, and the heat will help heal the injury. These sound waves are sent into the body using a transducer with no intent or way to capture any return they may have. Thus, no image is created. The sound waves are instead used and converted into heat energy.Medical ultrasound used for imaging purposes, including pregnancy, uses higher frequency sound waves. The transducer (the small wand-like structure used during the exam on the skin surface) creates these sound waves, sends them into the body, and when they bounce off of structures and return to the transducer they are captured and converted to mechanical energy and displayed on the monitor.
Using an Electromagnetic Spectrum diagram, UV radiation has a frequency range around 1016 Hz. This is higher than the listed frequency ranges used for radar, which are under 1010 Hz.
what is the reasion of using intermediate frequency in television system
What frequency are you on?
Yes. The piezoresistive effect was first applied to commercial pressure transducers, and remains very popular. However, many other sensors have been developed using this semiconductor property.
electronic volume can be measured by using transducer transducer is a device which convert non electrical signal to electrical signal. First you need a microphone which is a transducer after that apply the sound vibration on this microphone it will produce a voltage the voltage is directly proportional to applied sound volume level. it measure in decibel.
what working frequency are using shops alarms? /or car remote keys frequency ? who knows.... thanks.
You would be using a radio if you were trying to tune into an AM or FM frequency.
Oversampling is part of signal processing. It is the process of using a sampling frequency that is higher than the Nyquist rate to sample a signal.