Its value is strictly based on the quality of the gun. The Iver Johnson name will not sell it as the original co. went out of business years ago. Recent products under its name were not original or authentic designs. They were done by someone who bought the rights to the name. -- Which Does Not Answer the Question -- The Iver Johnson Silver Shadow, which is what you have, will bring $400-$450 in top condition. sales@countrygunsmith.net
On the bottom of the receiver forward the trigger
Stock group, receiver group, barrel group, and trigger group.
It is the 100th Anniversary Edition for Remington's making of the 870 pump shotgun. It runs for around $1200 and is a limited edition item. The Premier Dealer Wingmaster also has engravings on each side and a gold trigger. It has semi-fancy claro walnut stock and forearm.
Iver johnson
Model 1901 Iver Johnson, semi-hammerless, automatic ejector single gun.
The receiver of a shot gun is the part that receives the shell when you put it in the chamber. It is the part that contains the trigger. It is between the stock and the barrel. I know what it is I am just trying to find a short way to explain it, but I can't really.
Installing trigger guard in H&R Topper 88 single shot shotgun. I am not a professional gunsmith, so your mileage may vary, but this is how I _finally_ got it done. 1. The "trigger extension, the trigger, and the trigger guard have to all line up together, and line up with the pin holes in the receiver when the pin is inserted. It is next to impossible to get them to line up, and keep them lined up. Before in inserted the trigger guard into the receiver, I lined up the trigger, trigger extension, and trigger guard holes. Then I inserted two small splinters of wood from either side as shims and pushed them in tight until the holes stayed lined up. I cut the splinters off even with the outside of the trigger guard. After I inserted the trigger guard in the receiver, I got the trigger guard lined up with the pin hole in the receiver, then I hammered the pin through and drove out the wedges. 2. There are two opposing springs that fit in holes in the trigger guard. The rear one goes to the trigger. The front spring goes to the barrel break release. Leave the front spring out to start. Then after you get the trigger guard back in, you can hold the barrel break release up and drop the front of the trigger guard down just enough to insert the spring through from the front of the receiver.
First, clear the shotgun and make sure it is completely unloaded. Open the action halfway and unscrew the takedown screw. Pull the barrel forward and remove. Push the trigger housing pin out of the shotgun and pull down the rear trigger guard. Remove the cartridge stop and cartridge interrupter. Pull the bolt slide out of the bottom of the receiver. Push the forearm grip forward and off the gun. Push the bolt out of the hole where the barrel was. Move the elevator out of the bottom of the receiver and you are finished.
If it has one, it would be behind the trigger guard. sales@countrygunsmith.net
Pull the trigger
Depends on the shotgun.
The maker, model and serial should be somewhere on the receiver (the part around the trigger where the shells go in). You can look it up using that info. Or take it to a pawnshop or gun dealer.