In electrical terminology it is called a conductor. On PC boards it is called a trace.
There are many types of electrical circuits and each one is wired differently. Without knowing the specific circuit that needs to be wired, this question can not be answered.
schematic drawing
An electromagnet.
When you switch off an electrical circuit you tend to create a 'break' in the circuit, preventing the electric current to flow around the circuit, this can be caused by a simple switch or a break in the circuit, e.g a disconnected wire.
That is called a short circuit.
The wire comes from the installer or manufacturer of the circuit.
The wire in a circuit helps to pass power to the electrical appliances.
That's called electrical energy.
Current will cease to flow in a series electrical circuit.
If you mean a bare copper wire, that is the "ground" wire.
In a battery, or voltaic pile, the negative terminal or wire, called the anode, emits electrons in an electrical circuit. The other terminal, called the cathode, collects electrons in an electrical circuit.
The drawing of an electrical circuit is called a.............= schematic drawing.
Earth wire is meant to protect the user in case there is earth fault in the device or circuit. Only earth wire alone is not sufficient. It needs to be provided with suitable circuit breaker that breaks the circuit automatically.
A ground to earth completes an electrical circuit in some cases. The wire is called the ground or grounding wire, and often has green insulation.
No. An earth wire (commonly called a ground wire) has no current flowing through it. It is simply a wire connected to the ground to discharge electrical current in a circuit.
Of course. Aluminum is not the best, but it IS used for electrical wire.
An electrical circuit is a path which electrons from a current source flow. Electric current flows in a closed path called an electric circuit. The point where those electrons enter an electrical circuit is called the "source" of electrons. The point where the electrons leave an electrical circuit is called the "return". The exit point is called the "return" because electrons always end up at the source when they complete the path of an electrical circuit. The part of an electrical circuit that is between the electrons' starting point and the point where they return to the source is called an electrical circuit's "load". ---Nerd