kenwood car stereo kdc-mp528 wiring diagrahm
Kenwood car stereos have protect mode and sometimes it gets turned on. If someone wants to turn it off, they need to remove the stereo and unplug different wires to determine which one is causing the protect mode to be on.
there are a number of stereo wires but if you are installing a new stereo, it is worth buying the installation kit.it comes with a harness that will match all wires.
email adubitsky@lightcore.net
Replacing a car stereo is not a difficult process. All you need to do is take off the face plate, unscrew the radio, and unhook the wires. Then place the new stereo in, hook up the wires, screw the new stereo in, and replace the face plate.
To hook up stereo speakers in a truck, attach the stereo wiring to the stereo and run it to the speakers. Clip the stereo speakers into the wires and place them in the panel spaces in the truck.
to my stereo deck
Take the door apart, unscrew the speaker and there are the wires. They run from there to the back of your stereo system. If you pull out your deck you can see the other ends there
there is a wiring diagram on top of the stereo. you will see it as soon as the stereo is removed
make sure that speaker wires are not touching at all, this causes stereo to cut off
It happened to my Buick after I put in Stereo. The insulation was off one of the stereo wires causing a short which killed my dash lights.The stereo worked.My dash lights didn't.Check your radio wires and make sure its not grounding out.
The 1999 monster truck stereo wiring diagram can be obtained from most Mazda dealerships. The stereo has a wiring harness consisting of five wires.
They all should be attached to a wiring harness un less your install a radio then not all wires will be attached to the after market harness in most cases the wires that are not attached can be used to hook up subwoofers