Value chain analysis is the process to determine which process of production is increasing the value of product and which is not so that the product manufacturing cost can be reduced by eliminating that process from the production chain.
supply chain for bicycle manufacturing
The GCT is a value added tax, it is applied on the value added to goods at each stage of the production/distribution chain, It is applied to both imported and locally bought goods, GCT has consolidated several taxed such as stamp duty and excise duty.
Determining Costs: Use of Activity-Based costing in the management cycle where the main focus is managing activities rather than costs. Value Chain and Supply Chain analysis in the activity management. Identification of Value-Adding activities and eliminating Nonvalue-Adding activities. Eventually, from the cost hierarchy (Unit level, Batch level, Product/Service level and Operations level) the bill of activities are computed; and then the product unit costs are calculated.
The chain of production is the different stages involved in the production of a particular product :)
they keep your chain tight
A tight one...
It may not be getting enough lubrication, or the chain is too tight.
From the middle of the 2 sprockets you should have about an inch of slack or play in your chain when you lift up on the bottom of the chain with your finger if it looks a lot more then that adjust it but you don't want it to be too tight.
You need to start by adjusting the middle chain . At the front of the center chain is an eccentric , loosen the two bolts and rotate it to tighten . should be as tight as you can get it . After you do the center then you do the front .There is an eccentric for the front chain also . It should be as tight as you can also .
a tight chain
It must be fairly tight to stay on properly and not to slap around too much.
a tight chain
a tight chain
a tight chain
Chain too tight
If the machine has three chains , you need to tighten the center chain first . You want this chain tight with no slack . There is an eccentric at the front of center chain . Loosen the 2 bolts and rotate the eccentric to tighten the chain . With this tight do the front chain . This you want tight also , with no slack . The back chain needs to be tightened with the rider on machine . When you put weight on the rear of machine it tightenes the chain this is why rider needs to be on machine .There is 2 bolts on the rear eccentric that need to be loosened and then you rotate to tighten or loosen . With the rider on machine you want a half to 1 inch play in the center of chain . With no one on machine the chain will look loose but it is not .