Want this question answered?
go with 27 on the dwell and 4 btdc on timing
1963 390 firing order should be 1-8-7-2-6-5-4-3. dwell 30 deg. timing 5 deg BTDC.
Spark plug gap - .034" Point Gap- .021 M/T, .017 A/T Dwell Angle- 24 to 39 M/T. 26 to 31 A/T If the 390 was produced in 1962, the ignition timing was five degrees before top dead center ("BTDC"). If produced in 1963 and equipped with a manual transmission, the ignition timing was five degrees BTDC, and eight degrees BTDC if equipped with the automatic transmission. If produced between 1964 and 1966 and equipped with the manual transmission, the ignition timing was four degrees BTDC, and six degrees if equipped with the automatic transmission. If the 390 was produced in 1967 and not equipped with the Thermactor Exhaust Emission Control System, the ignition timing was 10 degrees BTDC. The ignition timing for all other 390s was six degrees BTDC.
Through my recent searches, I have came to understand that the ignition point gap of this vehicle having a 389 engine with a 2bbl carburetor is .016. The plug gap is .040 and the distributor dwell is 28 to 32.
American V-8 engines are commonly set with a dwell angle of 28-32 degrees. The point set is found under the distributor cap. It looks like a tiny record player arm without the turntable.Easy way:If you have a dwell meter, attach it as shown in the instructions.With the engine running and warm, open the little peep door in the distributor cap. Using a long screwdriver, turn the adjustment screw until the dwell angle is 28-32 degrees. I prefer 28 degrees to avoid advancing the timing too much at higher engine speeds.Reset the engine timing/idle speed. Remember to remove the vacuum advance and plug the end with a nail, tape, or golf tee. THIS IS A MUST.OR. If you don't have a dwell meter, be prepared for some more finesse.Remove the cap. Keep the wires attached if you can, but remove the coil wire so you don't get zapped.Find a friend to help with this. Bump the engine until the distributor lobe is holding the point armature open. It'll take a few tries.Insert a paper matchbook cover into the gap and turn the adjustment screw until you feel slight drag on the cover when you pull it out. (An old timer told me this trick and the dwell ended up at 30 degrees which I confirmed with a dwell meter I borrowed later.)If it's been a long time, or you don't know its condition, replace the condenser. It looks like a tiny ignition coil and only costs a few bucks to replace. The condenser prevents the points from receiving too much voltage and overheating which causes premature failure.Mount the distributor cap and reconnect the coil lead.Reset the engine timing/idle speed. Remember to remove the vacuum advance and plug the end with a nail or golf tee. THIS IS A MUST.My research says that the points should be checked every 3000 miles. I saw another claim that they'll last 10,000. Just check it as needed.
Breaking Point - 1963 Whatsoever Things I Hear - 1.10 was released on: USA:18 November 1963
Breaking Point - 1963 A Pelican in the Wilderness 1-8 was released on: USA: 4 November 1963
Breaking Point - 1963 Bird and Snake 1-4 was released on: USA: 7 October 1963
Breaking Point - 1963 Fire and Ice 1-3 was released on: USA: 30 September 1963
Breaking Point - 1963 Millions of Faces 1-12 was released on: USA: 9 December 1963
The Fugitive - 1963 Terror at High Point 1-13 was released on: USA: 17 December 1963
Breaking Point - 1963 Whatsoever Things I Hear 1-10 was released on: USA: 18 November 1963