its the outer aluminum or steel case the surrounds the internal componrnts
its in side the transmission case , can not be changed without removing the transmission and splitting the case
It is the part of the transmission case that bolts to the engine.It is the part of the transmission case that bolts to the engine.
The transfer case is bolted to the rear of the transmission Engine / transmission / transfer case ( front to rear ) on 4x4
It is on the front of the transmission case, below the cooler hoses.It is on the front of the transmission case, below the cooler hoses.
are you sure its the case and not 1 of the hoses ?
Remove all wires attached to the transfer case. Remove the driveshafts. Drain the fluid out of the transfer case. Place a transmission jack under the transfer case. Unbolt the transfer case from the transmission. Unbolt the crossmember the transfer case rests on.
Yes. Transmission in park or in gear, and transfer case in neutral.Yes. Transmission in park or in gear, and transfer case in neutral.
Fill plug on the side of the transmission case.
There is not normally a separate reservoir for the transmission Oil is held in the bottom of the transmission case.
If I understand the question right, if you have a transmission rebuilt the old case will be reused unless it is damaged.
The transmission solenoids are all together in one pack on the front of the transmission case, below the cooler hoses.The transmission solenoids are all together in one pack on the front of the transmission case, below the cooler hoses.
No, it's just the case.