Remove all wires attached to the transfer case. Remove the driveshafts. Drain the fluid out of the transfer case. Place a transmission jack under the transfer case. Unbolt the transfer case from the transmission. Unbolt the crossmember the transfer case rests on.
In most cases, you will find the speed shift sensor for your 1998 Chevy Blazer located on the backside of your transfer case. The transfer case is located on the transmission.
You will have to remove the transmission pan that is on the bottom of the transmission to drain the fluid.
It is bolted to the back of the transmission and then the driveshaft on the rear slides into it.
It can be. If it's an automatic with the electronic NP233 transfer case, you should remove the driveshaft. If you have a manual transmission or the manual NP231 transfer case, you should shift them into neutral.
It is on the valve body inside of the transmission. Remove the transmission pan and you will see it.
The automatic transmission fluid temperature sensor on a 1997 Chevy Blazer S10 is located on top of the transfer case. It is in the engine compartment.
can I put a 99 Chevy 4l60e transmission in my 86 k5 chevy blazer
Yes, they both had the same transmission options.
A 1996 Chevy Blazer Does have a transfer case IF it is equipped with 4 wheel drive
on the top of the transmission its on the transfer case with 3 vacuum lines coming out of it.
I have a Chevy 350 from a 1985 blazer in my 1990 wrangler. So yes it is. I also have the transmission and transfer case from it in my jeep to.
It don't have 1. you must remove the transmission pan to drain the fluid.