on the top of the transmission
its on the transfer case with 3 vacuum lines coming out of it.
The 2001 Chevy Blazer vacuum switch solenoid can be found on the firewall in the engine compartment. The vacuum switch solenoid will be on the passenger side of the firewall.
When this happened to me it was the three vacuum hoses on the transfer case switch were on wrong. There is a nipple on the switch and a hole in the vacuum hoses.
The vacuum switch/actuator for the fan shutter is under the dash directly below the radio . IT is NOT easy to get to.
I need a diagram for the 1991 Chevy blazer to see where the 3 hoses go to coming off the transfer case.
No. A Chevy Blazer does not have a reset switch.
There is no "kill switch" on that Chevy Blazer.
A 1996 Chevy Blazer Does have a transfer case IF it is equipped with 4 wheel drive
Un hook the electric conector on top of switch and screew it out with a wrench. EASY JOB
A 2000 Chevy Blazer is a GM vehicle. Vehicles made by GM do not come equipped with an inertia switch.
where is the fuel pump inertia switch located on a 2000 blazer
Under your battery tray
on the front axel
my chevy blazer 1984 the air conditioner blows from down side only.
Need to know the location of the vacuum leak in order to answer this.
The oil pressure switch on a 1998 Chevy Blazer is on the side of the engine block. It is located above the oil filter.
I just put a new transmission and have 3 hoses coming off the transfer case and need to know where to hook them to.
The vacuum pod should be under the battery tray on the passenger side. Usually the pod itself is good but the cable from it to the differential gets kinked or rots from battery acid. If you have small hands you can reach it and squeze it to see if the cable is moving!
They were not used on Chevy trucks.
You can find a diagram for the vacuum system in a 1995 Blazer 4x4 will be located in the Blazer service manual. The manual can be purchased in most auto parts.
Check for vacuum leaks.
Vacuum pump? Is this a diesel?