yes
Yes assuming the ballast is also for a metal halide lamp.
If the ballast on a fluorescent light blows the lamp will not work.
For your question, i see the ignitor means the Electronic Ballast. If you want test HID lamp electronic ballast, you can reference Lisun WT2000-HID HID Ballast Tester, this instrument is main for test HID lamp electronic ballast,
Not recommended. It would work but shorten lamp life and may cause risk of fire. However, if you just wanted to check a lamp was capable of striking it would be ok for a few minutes. I've done the opposite in the past and used a 150w lamp with a 100w ballast. Works, but not good for any of the components, including lamp.
yes
yes
No, the ballast has to be matched to the lamp. 250 watt ballast, 250 watt lamp. Also be sure to match the lamp type to the proper ballast even though the wattage is the same. HPS ballast to HPS lamp, Metal halide ballast to metal halide lamp and mercury vapour lamp to mercury vapour ballast.
No. The lamp has to match the ballast. The lamp will not ignite if the wrong ballast is used.
Yes assuming the ballast is also for a metal halide lamp.
If the ballast on a fluorescent light blows the lamp will not work.
For your question, i see the ignitor means the Electronic Ballast. If you want test HID lamp electronic ballast, you can reference Lisun WT2000-HID HID Ballast Tester, this instrument is main for test HID lamp electronic ballast,
Not recommended. It would work but shorten lamp life and may cause risk of fire. However, if you just wanted to check a lamp was capable of striking it would be ok for a few minutes. I've done the opposite in the past and used a 150w lamp with a 100w ballast. Works, but not good for any of the components, including lamp.
Do you have the right ballast for the type of lamps you are using? Check on the nameplate of the ballast to see it matches with the type of tubes you are using. Are the tubes snug in the lamp holders? Is the fluorescent fixture grounded using the fixture ground screw? Do you have voltage to the ballast? On most lamp start ups you can see the lamp filament glow on each end of the tube. If you don't see the filament glow on any of the tube ends, check the wires going to that lamp holder.
a compact electronic ballast in the base of the lamp
No. The bulb has to match the ballast wattage exactly. And you can't interchange different lamps (like metal halide) either. The ballast is specific to that wattage and lamp type. The bulb will either burn out quickly or just not work properly at all
Yes, a ballast is required for HPS (high-pressure sodium) lights. The ballast helps regulate the electrical current and provides the initial high voltage needed to start the lamp. Without a ballast, the HPS light would not function properly.