answersLogoWhite

0


Best Answer

ur gear box or clutch has gone take it to ur local garage!!?

User Avatar

Wiki User

15y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: What is wrong if your engine will turn on but your car will not stay in gear?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Engine noise between first and second gear?

turn the engine off


How does a stater work on a engine?

The starter, upon activation, has a gear that is forced onto the engine's flywheel's gear to turn the motor over. Upon engine start or release of the start voltage the starter gear disengages.


Can a Hemi turn the check engine light on for the wrong oil?

Yes, it can turn the light on for the wrong oil.


Will the electric fans stay on after you turn engine off on a 1998 deville 4.6L?

will the electric fans stay on after you turn engine off on a 1998 deville 4.6L


If the Firing order is wrong will the engine turn over?

The engine will turn over , but either run poorly or not at all


What wrong with your four wheeler it will get in gear an the chain will turn but it wont move?

rear end is no good


Why wont a distributer turn?

if your talking about when your cranking the engine over with the cap off, then you have a broken distributor gear or shaft or bad camshaft gear.


How do you turn the engine off the range roover?

If your engine does not turn off by the key I suggest disconnecting the battery and alternator and immediately fixing what is wrong


Why gear with less number of teeth has poor strength?

It depends if the gear is driving or being driven. A large gear pulling a smaller one gives speed, while a small gear pulling a larger one gives power. The reason has to do with the number of times they turn in relation to each other. That is also known as the gear ratio. For instance, if a gear has to turn a gear that's ten times it's size, the drive gear has to turn ten times before the output gear turns once, thus converting speed to power. However, a gear driving a gear that is 1/10 its size means that the driven gear would get to turn ten times for each time the driving gear turns, thus converting power to speed. In practical usage, keep in mind that older manual transmissions were made to where all the forward arrangements but the 4th gear were made to where the driving gear (the one connected most directly to the crank shaft of the engine) is smaller than the driven gear. So in the first three gears, the engine turned faster than the drive shaft. In those transmissions, 4th gear usually had both gears in that set the same size so the drive shaft is turning at the speed of the engine, Then once automakers began to add overdrive, that meant that 5 and higher gears were paired to where the driving gear (engine side) is larger than the driven gear (drive shaft side) to allow the drive shaft to turn faster than the engine.


What is wrong when the Starter engages but engine does't turn over?

the engine is locked up. Not good. Very expensive.


How do you fix a check engine light on a 94 Corsica?

you need to take it to a mechanic because they have a machine to turn it off. they will run a diagnostics test. when they turn it off it may come back on a few days later. there may be nothing wrong with the engine, but that light may just stay on all the time anyways


What is wrong with a Kia Sedona when you turn the engine and it just clicks?

It means your battery is dying