Kinda vague huh? from the first impression it sounds like you blew a coolant hose and the smoke you saw was steam from the coolant hitting the manifold. But if you had to remove the spark plugs to see the water then you have blown a head gasket.
No, that's usually water getting into cylinders.
pull spark plugs cycle engine by turnkey or manually if water is spit out you were hydrolock
Is the white smoke coming out of your tailpipe when the engine is warmed up ? If so , it sounds like coolant is getting into an engine cylinder from a bad head gasket , warped or cracked head
water could have gotten into the spark plug holes. water + spark= no good. Only a few spark plugs could be firing, take them out, and check for water.
If you have water on your spark plugs you have a serious problem. That is coolant you see and not water. You have a blown head gasket or cracked head. This engine will self destruct if you continue to drive it. Have this repaired ASAP and stop driving it until you do.
Becuse someone washed the engine. Or the plug covers have bad seals and somehow when it rains water is splashing into the engine.
Depends on the type of flooding. Hopefully the gas flooded and not the water flooded. If it's flooded by gas try starting it with throttle wide open. If it doesn't work after a while, remove spark plugs and crank engine over for few seconds (remember to watch out for the spark) Install new spark plugs. If the engine is flooded from water, you will have to remove the spark plugs and crank on it for a while till all water comes out. *I have personal experience here* Install spark plugs and attempt to start, if not remove plugs and keep cranking. It may fire for a second or two. Keep removing spark plugs to dry them off and crank some more. Keep this up back and forth for a while, or till engine fires up.
You have either A blown head gasket, A cracked head or a cracked block, alowing water from your cooling system to enter the chamber. this will result in water also finding its way into the sump ruining the oil . stop the motor and dont run it till it is fixed. The water is coming out of the hole where the spark plugs screw in ? - Then water has gotten into the engine or is getting into the engine while driving in the rain or washing, it is unlikely that the water is actually coming out of the spark plugs themselves.
Because there is a design flaw in the Kawasaki water cooled engine.
Remove all spark plugs and turn it over to blow the water out. Change the oil/filter, install the plugs and start it up.
take out the spark spugs and crank the engine over until you pump all the water out of the combustion chamber......spray some starting fluid in where the spark plugs go...put your spark plugs back in and see if it will fire back up. This is considering you only hydrolocked the motor by sucking water in through the intake....hope this helps
Water around the outsides of the spark plug may keep the car from running due to poor spark plug wires, but the engine should still turn over.