Want this question answered?
What I think is at the bottom of a whirlpool. I think that there is just water that's keeps spinning and spinning. T.W.
false
Friction by spinning a wooden stick in a hole in a second piece of wood. A wheel bearing not properly lubricated
The two wheels on the bicycle act as gyroscopes, so their spinning is what keeps them upright. While the wheels are not spinning the gyroscopic force is not there, so, of course, it falls over just as a pyramid placed on its tip would.
Rotational Inertia keeps the roll from spinning while the paper is ripped therefore it is easier to tear it.
the diameter of the bearing and the bore of the knuckle bore of the 2005 ford focus front bearing
it is a spinning motor thing and it makes the weels go round Bore is the diameter of the cylinders.
I'm not sure what the question is, but I'll do my best to elaborate on the Center Support Bearing. Basically, it is a free-spinning bearing that keeps the driveshaft aligned properly. Without this bearing, the driveshaft will "wiggle" and knock around, possibly causing damage to the driveshaft's U-Joint. I've been told they are around $250 from Nissan.
bear - is bearing - bore - borne or born
need to replace thrust bearing
It is conservation of [angular] momentum.
Shoot the duck is a move in figure skating were the skater begins spinning and squats down and keeps spinning while extending the leg... keeps spinning for a couple seconds then tucks in leg and pushes up gracefully while still spinning.
What I think is at the bottom of a whirlpool. I think that there is just water that's keeps spinning and spinning. T.W.
The bore is rifled so as to put a spin on the bullet. This spinning gives a greater accuracy to the bullet, especially over that of a smooth bore.
false
OD-51mm x Bore-25mm x Depth-12mm
it may be bad bearing (bore bearings).