answersLogoWhite

0

It would have been built with R12, can be converted to R134a.

User Avatar

Wiki User

17y ago

What else can I help you with?

Related Questions

Does a 1989 Toyota Tacoma have airbags?

well, considering that there is no 1989 Toyota tacoma, i wouldn't think so..if you're talking about a 1989 Toyota pickup, then no


Where is the air conditioner drain for a 1989 Chevy truck?

Your 1989 Chevy truck air-conditioner condensation drain can be found on the bottom of the air conditioner compressor. The air conditioner condensation drain routes condensation to the bottom of the engine compartment.


Where is the taillight controller on 1989 Toyota?

Whooops I for got CAMRY... 1989 Toyota Camry!


How to Replace speedometer cable 1989 Toyota truck?

Speedometer cable replace 1989 toyota


1989 Toyota Corolla SR5 sport coupe and it is leaking antifreeze under the bottom in front of the engine?

There are a few things that can cause a coolant leak but in your case it is probably the water pump. When a water pump starts to go bad it will leak coolant from the bottom.


What size speakers fit a 1989 Toyota Cressida?

what size speakers fit in a 1989 Toyota cressida


Why is the electric coolant fan in your 1989 Oldsmobile cutlas cierra not working?

Why is the electric coolant fan in your 1989 Oldsmobile cutlass cierra not working?


Where is the airbag located in a 1989 Toyota Camry?

Don't think the 1989 Toyota Camry came with an airbag system.


Toyota Camry air filter 1989?

air filter cabin toyota camry 1989 that where? show me, thanks


Where is the coolant sensor located on a 1989 Chevy 350 tbi?

The 1989 Chevrolet 350 cubic inch engine coolant sensor is located on the front of the engine. The coolant sensor will be near the thermostat housing.


Where do you add freon to the air conditioner on a 1989 Toyota SR5 Pickup?

To add freon to the air conditioner on a 1989 Toyota SR5 Pickup, locate the low-pressure service port, which is typically found on the larger diameter aluminum line running from the compressor to the evaporator. Remove the cap from the service port and connect the refrigerant can's hose to it. Make sure the engine is running and the AC is set to the maximum setting while you add freon. Always check the manufacturer's specifications for the correct type and amount of refrigerant.


How do you flush the radiator in a 1989 Toyota Cressida?

To flush the radiator in a 1989 Toyota Cressida, first ensure the engine is cool and then remove the radiator cap. Drain the old coolant by opening the drain valve at the bottom of the radiator and allowing it to flow into a container. Next, fill the radiator with a mixture of water and a radiator flush product, running the engine for about 10-15 minutes with the heater on to circulate the solution. Finally, drain the flush solution, rinse with clean water, and refill with the appropriate coolant mixture.