answersLogoWhite

0

You must correct what is wrong with it before it will work.

User Avatar

Wiki User

8y ago

What else can I help you with?

Related Questions

How does a circuit work you must use the word electron?

a path of continuous electrons. may include switch but must have load or will short circuit.


Does it matter where you place an ammeter in a circuit?

Ammeters must always be placed in series in a circuit, otherwise they will not work babes :)


How the circuit work?

An electrical circuit must be complete i.e it must form a closed loop,for it to work. Current only flow if the circuit is complete. A complete circuit is one that consist of a Voltage source, a consumer like a bulb and conductors. The conductor then connects the consumer and the voltage source together forming a closed loop.


How circuit work?

An electrical circuit must be complete i.e it must form a closed loop,for it to work. Current only flow if the circuit is complete. A complete circuit is one that consist of a Voltage source, a consumer like a bulb and conductors. The conductor then connects the consumer and the voltage source together forming a closed loop.


Will battery terminals work if they touch rubber?

Your question is unclear. However rubber is not conductive. A circuit is required for electricity to flow, the circuit must be of conductive materials.


What happens when one light bulb burns out in a series circuit?

All of the light bulbs in the series circuit would go out.


Where isolators are placed in substation?

An isolator is a non load-breaking switch, and is provides a visible means of isolating a component, such as a circuit breaker, transformer, etc., from the high-voltage lines, whenever it is necessary to perform maintenance of that component. Normally, isolators come in pairs, with one on each side of the component to be isolated. Isolators are only opened afterthe load current has been broken using a circuit breaker, and must be closed before the circuit breaker is reclosed.To work on, say, a h.v. circuit breaker, the breaker must be tripped, the isolators on either side must be opened and locked off, temporary earths attached to either side of the circuit breake- to-work card, detailing the maintenance work, must be issued to the crew by the supervising engineer.


What has to be in plce for a circuit to work?

For a circuit to work, it needs a power source (such as a battery), conductive pathways (wires or circuit traces), a load (such as a light bulb or motor), and components like resistors, capacitors, and transistors to control the flow of electricity. Additionally, the circuit must be closed or complete, meaning that there is a continuous pathway for the electricity to flow.


How can a circuit breaker be changed without the presence of a main breaker?

To change a circuit breaker without a main breaker present, you must first turn off the power supply to the circuit at the main electrical panel. Then, remove the cover of the panel and locate the circuit breaker that needs to be changed. Carefully disconnect the wires connected to the old breaker and replace it with a new one of the same size and type. Reconnect the wires and securely fasten the new breaker in place. Finally, replace the panel cover and restore power to the circuit.


How must a circuit be created so that the rest of the bulbs stay lit if one goes out?

the circuit must be wired in parallel.


In what type of circuit does electricity travel when it does work?

Electricity travels in a closed circuit when it does work.


What type of circuit does electricity travel when it does work?

Electricity travels in a closed circuit when it does work.