0
What else can I help you with?
What must be changed for circuit to work?
You must correct what is wrong with it before it will work.
What are some reasons an electric circuit would not work?
The switch may be off or there is a break in the wire that stopped the electron flow in the circuit
Does it matter where you place an ammeter in a circuit?
Ammeters must always be placed in series in a circuit, otherwise they will not work babes :)
What journey does an electron make in a battery powered electric circuit?
In a battery-powered electric circuit, an electron travels from the negative terminal of the battery, through the external circuit (where it powers devices or performs work), and then returns to the positive terminal of the battery. This flow of electrons creates an electric current that powers the circuit.
How the circuit work?
An electrical circuit must be complete i.e it must form a closed loop,for it to work. Current only flow if the circuit is complete. A complete circuit is one that consist of a Voltage source, a consumer like a bulb and conductors. The conductor then connects the consumer and the voltage source together forming a closed loop.
How circuit work?
An electrical circuit must be complete i.e it must form a closed loop,for it to work. Current only flow if the circuit is complete. A complete circuit is one that consist of a Voltage source, a consumer like a bulb and conductors. The conductor then connects the consumer and the voltage source together forming a closed loop.
Will battery terminals work if they touch rubber?
Your question is unclear. However rubber is not conductive. A circuit is required for electricity to flow, the circuit must be of conductive materials.
What happens when one light bulb burns out in a series circuit?
All of the light bulbs in the series circuit would go out.
Where isolators are placed in substation?
An isolator is a non load-breaking switch, and is provides a visible means of isolating a component, such as a circuit breaker, transformer, etc., from the high-voltage lines, whenever it is necessary to perform maintenance of that component. Normally, isolators come in pairs, with one on each side of the component to be isolated. Isolators are only opened afterthe load current has been broken using a circuit breaker, and must be closed before the circuit breaker is reclosed.To work on, say, a h.v. circuit breaker, the breaker must be tripped, the isolators on either side must be opened and locked off, temporary earths attached to either side of the circuit breake- to-work card, detailing the maintenance work, must be issued to the crew by the supervising engineer.
What has to be in plce for a circuit to work?
For a circuit to work, it needs a power source (such as a battery), conductive pathways (wires or circuit traces), a load (such as a light bulb or motor), and components like resistors, capacitors, and transistors to control the flow of electricity. Additionally, the circuit must be closed or complete, meaning that there is a continuous pathway for the electricity to flow.
The work done to move one electron in a light bulb is very small?
The work done to move one electron in a light bulb is small because electrons are lightweight particles with a small charge. The work done is a result of the electric field in the circuit, which provides the energy for the movement of electrons to create light.
What must you always do when using a word processor?
Save your work often.
