Want this question answered?
In order to replace a Renault Megane Scenic drive shaft gaiter, a boot kit can be purchased. This kit not only includes all needed parts including the required lubrication but also a step by step guide to replace the boot. Installation includes splitting the drive shaft and repacking the bearings so proceed with caution.
In order to reset the airbag light on a Renault Megane, you will need to take your vehicle into an auto body shop. You cannot reset it yourself.
A cheap Renault Megane can be purchased directly from a private owner in order to cut out the middle man. However, it is wise to have the car inspected by a reputable auto repair shop to avoid buying a lemon.
In order to fix a horn on a Renault Megane you will need to first purchase the parts required such as a new horn from your local auto parts store. Then it is best to take the car to an automatic to make sure the horn is properly installed.
In order to remove the key card reader from Renault Megane the cover surrounding it on the dashboard must be removed first to gain access to the reader. Removing the reader all together would cause the car to stop functioning.
The coil springs are not easy to remove or install. The spring needs to be compressed in order to be removed. It takes several hundred pounds of pressure to compress the spring.
You can adjust the brake pistons by adjusting the brake piston adjustment screw. Turn the screw to the right in order to back off the brake piston.
Being a BMW, its unlikely but not unheard of. For instance, the Renault Megane needs the bumper, light unit and cross bars off to change a bulb.
Timing belts last 60 to 100 thousand miles, and should be changed accordingly. The easiest way to make sure your timing belt is in working order is to bring it to a local mechanic.
In K9K engine series: If you mean the tdc in order to lock crankshaft to replace timing belt, in front of the engine near the flywheel zone right below the oil pressure valve there is a small bolt (usually with a torx head "star"). Removing that bolt and inserting a special locking tool through that hole ,will lock crankshaft right on the tdc. No he means the TDC Sensor which is on top of the bell housing it is held in place on a banana shaped plate which is bolted to the engine with 2 10mm bolts.
It is important to know the firing order of a vehicles engine. The firing order for a Renault V6 is 1-5-3-6-2-4.
This is a Renault only part. You will have to visit a auto recyclers or order it from Renault.