The distances from the root to the edges of the legs (toes) and the height of the crown are basic measurements. If the face is concave it might be considered.
The filet is part of the radius, therefore making the term filet radius. A filet radius measures an inside corner. A corner radius measures an outside corner.
Very likely to leak, zinc in the GI pipe will be contaiminating the weld and thus you cannot get a good weld.
Because a perimeter is measured in linear units while an area is measured in square units.
Volume is measured in cubic units
minus weld gaps and takeoffs from total then multiply for angle.
leg,toe,face,throat,root joint
Pitch is center to center spacing of an intermittent weld.
Eat a banana.
Leg of the weld. Fillet is the part you cut off e.g. a corner...
The 'face' of the weld may be slightly convex, flat, or slightly concave.
Pitch
wildly welding main pipe the are fillet weld or butweld
tell me full penetration joint process
A fillet weld in any single continuous weldmay underrun the nominal fillet weld size specified by2 mm [1/16 in] without correction, provided that theundersize portion of the weld does not exceed 10% of thelength of the weld. On the web-to-flange welds on girders,underrun shall be prohibited at the ends for a lengthequal to twice the width of the flange.
In a fillet weld, the leg and size are the same for the convex weld.
The crown of the weld is the material of the filler metal that projects above the surface of the parts being joined by the weld.
It is the only type of weld you can make to seal this type of joint. There are flange ends that can be welded onto pipe with a butt weld, but sockets and slip-ons must be fillet welded.