0
Eat a banana.
Wiki User
∙ 11y ago
Add your answer:
Earn +20 pts
Leg or filet weld?
Leg of the weld. Fillet is the part you cut off e.g. a corner...
What is the difference between Full-penetration butt welds and filet butt weld?
tell me full penetration joint process
How do you measure filet weld?
In a fillet weld, the leg and size are the same for the convex weld.
Why is filet weld necessary while welding slip on flanges to a pipe end?
It is the only type of weld you can make to seal this type of joint. There are flange ends that can be welded onto pipe with a butt weld, but sockets and slip-ons must be fillet welded.
What welding defect is considered the most severe?
1. Surface Cracks 2. Under bead / HAZ crack 3. Root Crack 4. Inclusion 5. Concave profile 6. Weld undersize.
What part of a filet weld that can be convex or concave?
The 'face' of the weld may be slightly convex, flat, or slightly concave.
What parts of a filet weld are measured?
The distances from the root to the edges of the legs (toes) and the height of the crown are basic measurements. If the face is concave it might be considered.
What is pitch of a filet weld?
Pitch is center to center spacing of an intermittent weld.
Leg or filet weld?
Leg of the weld. Fillet is the part you cut off e.g. a corner...
There are 3 types of filet welds name them?
concave, convex and the other one which is niether concave or convex
What term refers to the center-to-center spacing of intermittent filet weld?
Pitch
What is the filet weld size required for weldolets to main pipe joint?
wildly welding main pipe the are fillet weld or butweld
What is the Five parts of a filet weld?
leg,toe,face,throat,root joint
What is the difference between Full-penetration butt welds and filet butt weld?
tell me full penetration joint process
What is definition of the under run in filet weld?
A fillet weld in any single continuous weldmay underrun the nominal fillet weld size specified by2 mm [1/16 in] without correction, provided that theundersize portion of the weld does not exceed 10% of thelength of the weld. On the web-to-flange welds on girders,underrun shall be prohibited at the ends for a lengthequal to twice the width of the flange.
How do you measure filet weld?
In a fillet weld, the leg and size are the same for the convex weld.
Why is filet weld necessary while welding slip on flanges to a pipe end?
It is the only type of weld you can make to seal this type of joint. There are flange ends that can be welded onto pipe with a butt weld, but sockets and slip-ons must be fillet welded.
