0
It is know as an Air Medal
Wiki User
∙ 12y ago
Add your answer:
Earn +20 pts
Yes with the 4 and 4s and the 5 requires a lightning adapter to 30 pin.?
Yes with the 4 and 4s and the 5 requires a lightning adapter to 30 pin.
What is the Crumpetmonger holding in her tail?
rolling pin.
What is the torque specs for the brake caliper mounting bolts on a 2005 Nissan Frontier?
32ftlbs for the pin bolts
What is special about the wedge tail eagle?
the wedge tail eagle has binocular vision that alows thenm to pin point there prey
I've found a pin and I'm not sure it's a navy pin from ww 2 or the boyscoutsWhat is the eagle cross pin?
Would have to be more specific but sounds like a pin from the WW1/WW2 era
What is the value of 1984 Olympic pin collection with Sam the eagle?
around 200
Why is your suzuki samurai transmission stuck in gear?
the pin is broke inside the shifter case. put it in neutral, if possible, and unbolt the 4 bolts holding the case in place. it should take a 12mm. once you remove the shifter, the little pin inside the shifter case should be wiggly. just replace it. i did it when i was 12
Douglas DC-4 British eagle G-ASPN?
G s gold eagle pin with four stars n sheild
How do you change the fuel pump in a 327 Chevy Small block Think it is 1968?
it is located on right front of block. First remove your fuel lines, the remove the retaining bolts holding it on the pin will slide out after the pump. coate the pin with grease and reinstall in its hole(grease will hold it for you so you can get the pump in) the install pump and lines
Why it is safer to approach it while holding a pin in front of you?
i have no idea lol
Which ones are the caliper to pin bolts?
The ones obviously going through the caliper body.
2001 Buick lesabre front caliper mounting bolts which one goes top or bottom there is a difference in them?
The top (or leading) pin bolt uses the plastic bushing, the bottom bolt should be solid. Here is a snipet from a manual.Install the caliper over the rotor and onto the caliper bracket. Ensure that the caliper pin boots are not pinched. NOTE: The leading caliper pin, or top pin, has a bushing as part of the assembly. The trailing caliper pin, or bottom pin, is a solid design.Install the new caliper pin bolts (1) and tighten them to 70 lb ft (95 N.m). NOTE: It is important to note which caliper pin is designed for the correct bore. The leading caliper pin, or top pin, has a bushing as part of the assembly. The trailing caliper pin, or bottom pin, is a solid design. Ensure that the bolt boots fit securely in the groove of the pin bolts. Be sure not to pinch or tear the boots. If the boots are damaged, they must be replaced.
