0
What else can I help you with?
Where is the turbine speed sensor TSS located on a Mazda 626 2001 auto cd4e?
Its located on the back of the oil pump. Take the left tire off and the splash guard and you should be able to spot it, its the only sensor on the trans pump Its located on the back of the oil pump. Take the left tire off and the splash guard and you should be able to spot it, its the only sensor on the trans pump
Where is the speed sensor on a 2000 Dodge Ram 1500?
The vehicle speed signal comes from the abs sensor on top of the rear axle. (used for speedometer) The transmission output speed signal comes form the sensor on the driver side rear of the trans. ( used for shift timing only)
What do you do if your speedometer and odometer are working only intermittently on a 1997 Honda Civic EX coupe?
Check out the wiring for the speed sensor located on the trans,. GoodluckJoe
Where is the speed sensor located for a 1996 Mazda 626?
above right side halfshaft input into trans. can only be seen under neath the car.
Location of speed sensor for 1999 dodge ram 1500 4x4?
On the 98 there are two in the front, one on each wheel and the rear might have one in the pumpkin. The one in the top of the rear axle is the main speed sensor, the front sensors are only there if it has 4 wheel abs. The vehicle speed sensor is located on the top of the rear axle.
Exactly where are the two transmission speed sensors located on a 1995 Acclaim 3 speed?
A three speed only has one speed sensor. It is located on the case where the right axle shaft comes out. The 4 speed has the two sensors.
What causes trans axle to slip when going into third gear?
If it's only when you attempt third gear the problem is in your transmission.
How do you replace the Speedometer cable on a 97 dodge ram?
there is no cable only speed sensor on trans
Where is the crankshaft sensor located on a 1991 dodge caravan 2.5L?
No crank sensor, only the sensor in the distributor.
Why won't axle on 1994 sunbird come out from transmission?
You must drain the transaxle-(transmission). Then remove the back plate on the trans axle (located on the back side of the section where the axles go in) with this plate removed you will see a large ring gear on the left,----- in the center of this opening there are two smaller gears the axle ends are going though them. Put a large flat screwdriver in there one side against the end of the axle the other side against a large pin in the center hit the end of the screwdriver with the palm of your hand to get it in there good and pry the axle out (this won't be very much pressure ) repeat for the other axle. Note!!!!!!!---on manual tansaxles only remove one axle at a time. Do not take them both out at the same time gears will fall into trans.
Where is the oxygen sensor on a 1990 pathfinder located?
The oxygen sensor is located on the exhaust manifold and is the only item on the exhaust with wires going to it.
Where is the iat sensor located on 1999 grand prix?
This sensor is located on the air intake track. This sensor will only have two wires coming from itÊandÊthis sensor is also called the throttle body.
