0
Same side as the fuse.
Wiki User
∙ 11y ago
Add your answer:
Earn +20 pts
What wire in a circuit should contain the fuse?
The live wire
Before you touch a wire in an appliance how should you make sure that it is NOT hot?
You can use a wire tester to determine if a wire is live. You can also touch the positive wire on the ground wire, if the wire produces a spark it is live.
Why should a person never touch another person who is in contact with a live wire?
You should never touch a person in contact with live wire because the electricity will get run thru the body ad also get to you.
Should 230Volts exits between live wire and protective earth?
yes
Should neutral wire of lamp be connected to the 3amp or the 6 amp side of a canopy switch?
You should never switch the neutral wire. The neutral of the appliance should be connected directly to the neutral wire leading to the service panel neutral bar.
A fuse should be conected between?
A fuse should be connected in the live wire, before reaching the appliance.
Does the live wire from the ignition key go to the bat terminal and a live wire from the starter go to the tach terminal on a hei distributor for 350 Chevy in a boat with non standard wiring?
You do need a switched live to the bat terminal, but not to the tach terminal. The tach terminal is the negative side of the coil, the bat terminal is the positive side of the coil. Normally the tach terminal is for the green wire from the tach.
How do i check to see why my Rear speakers are not working in 2001 blazer?
take the speaker out and run 2 wires from the speaker one on positive side and one on the negative side the use a 9volt battery and touch one wire to each side the speaker should make a popping sound moving either up or down depending on which wire you have where. if you touch the positive wire on the positive side of the battery it should move out and if reverse should move in. if it does not do anything the speaker is blown.
How do you convert don't touch live wire to passive form?
Live wire is not to be touched. or Live wire touch not..haha
What is the most common way of making electrical connections?
The most common way of making an electrical connection is with a device called a wire nut. Solid wire connections should be twisted together with a pair of pliers before installing the wire nut to hold the splice tight. Twisting stranded wire together with a pair of pliers does not allow the wire nut to grip the wires as tight as it should. Stranded wire should be held together side by side (in parallel) and let the wire nut twist the wires together to make a solid splice connection.
What is the most common way of making an electrical connections?
The most common way of making an electrical connection is with a device called a wire nut. Solid wire connections should be twisted together with a pair of pliers before installing the wire nut to hold the splice tight. Twisting stranded wire together with a pair of pliers does not allow the wire nut to grip the wires as tight as it should. Stranded wire should be held together side by side (in parallel) and let the wire nut twist the wires together to make a solid splice connection.
How do you Connect on and off switch between continuous wire?
First you turn off the power. Then you cut the wire. Strip each end of the cut wire and attach to each side of the switch. This should only be done within a switch enclosure. If there is no extra wire to make a good connection, you can extend the cut ends with wire of the same size as the cut wire and use wire nuts to securely connect the "pigtail" wires. You should only switch the hot side (Black wire in home wiring) and not the white wire which would pose a shock hazard.
