Want this question answered?
the controller
A jumper is used to complete a circuit on a motherboard or other device and thus signal a certain mode of operation, such as "the BIOS should be in recovery mode" or "this hard drive is the Master device."
a digital signal that can disconnect from the line it is driving to let something else drive it
indicates drive A
Drive Test in BTS (BASE TRANSCEIVER STATION) is used to find out the signal strength or RX level of the signal. It is done by the mobile having TEMS software.
The HOLD pin indicates that an external device wants the 8085 to stop and allow the external device to drive the bus. The acknowledge of control transfer is HLDA, however, it is important to note that HLDA does not mean the current cycle is complete - it means that the current cycle is the last cycle, at which point the 8085 will release the bus. (One half clock cycle later.)
Sends a signal to the computer which translates said signal into a different signal and sends it to the speedometer.
It indicates that there is a relationship between arousal and performance.
The x factor of a drive indicates the speed of the drive and one x equals 500 RPM
An amplifier that is designed to amplify the signal from an electric guitar and drive a speaker to convert that signal to sound.
No, it does not need a flash drive.
Stop, signal, yield, pay attention