Want this question answered?
In order to weld pieces of 6mm steel you can use any type of welder. Depending on how strong and how pretty the weld needs to be will determine the type of welder you choose.
Calculate cross sectional area of 10mm bar amd 8mm bar, then divide them and you will get the no. of bars. For Eg. - Area of 10mm bar = 78.53 sq.mm Area of 8mm bar = 50.26 sq.mm No. of 8mm bars in replacement for 10mm bar = 1.562 bars [ theoritical] In practical u'll provide 2-8mm bars.
It depends. How large is the steel plate? How thick is it? This makes things vary. For example: A fat man would weigh more because, he is wider. or thicker A 1/4 thick by 1in wide by 12 in long plate weights 0.85 LB.
According to my research in order to become a Welder you will need to take a test to receive your Welder's certificate. Once you get the certificate you can apply for jobs.
on top of the manifold under the plate that says"PCV VALVE" you will need to remove two 10mm bolts...
When you refer to a 200 amp welder you are talking about the output side of the welder. What you have to do is find out what the input voltage and current of the welder is to calculate the size of a generator needed to operate the welder.
that depends on the size of the welder. some welders can be used with a 110V outlet and others need a 220V. the size of the welder is the decider on that. Tech Ed Ted
I need to calculate the stress resulting from a torsion moment on a hollow steel section as well as a flat plate.
To know the force, you need to know how much you want to bend it; you also need to know the dimensions of the plate and how it is supported.
You will need a 'step up transformer' but it is important to provide the details on the information panel of the welder before ordering
The wire size depends on the amperage, not the voltage. The fact that the welder runs on 440 volts does not affect the wire size! You need to ask this question instead: What size wire do you need for a three phase welder on an eight foot run if the nameplate amps are 45A?
Yes because you may need to figure out where to weld by using math