On a Arien's mower you will use 46 inch belt. This is an older type lawn mower.
Depends on the model and year of the one you are referring to. You can find out here:http://www.arienspartstore.com
12
I just used a 5/8 V-belt ( 5/8 on top x 3/8 high) x 142" long.
Most any belt can be taken to almost any auto parts store and they'll sell you one for a lot less than the mfgr. It'll fit and the last one I bought ran for two years on a lawn tractor that was used to haul dirt and firewood.
1/2x33 inch belt, manual calls for a 1/2 x32.60
It takes an 82 inch five grove belt.
depends... most yards that riding mowers are used on are $50.00 & up depending on size
Ariens is a commercial grade supplier of equipment. Their products run from 800 to1800$ new. Their used cost will depend upon condition and how good a deal you got. Probably half those prices for the same snowblowers.
You will find a link below and will need the model number beginning with 915, the last three digits match the deck and engine. I used 24001 as a fill-in for serial number since about any number below 25000 will work.
i just looked at one yesterday...as my storage space for my new "used" lawn mower is limited it imperative that i measure the deck to make sure it would fit. my entrance is 42" and we measured the deck at its widest point and it is 40", so it will be a tight fit if i buy it
2 21inch blades.
74"
The mower is used on the grass. A drill can be used to dig holes for bulbs. A sprayer is used to spray insecticide.