It varies from vehicle to vehicle.
Disconnect the fuel filler hose, drop the gas tank, remove the pump.
This would depend on how big your fuel pump is, every fuel pump is diffrent.
I have a 96 Ford Escort LX. I need to replace the vent and the fuel intake rubber hose that come from the gas tank. Can you tell me what size both hoses are?
form_title= Colored Fuel Hose form_header= Create a look all your own with a colored fuel hose. What color would you like?*= _ [50] What size would you like the hose?*= _ [50] Do you need any special fittings for the hose?*= () Yes () No
If it is fuel injected the fuel pump will be located inside the fuel tank.
5mm. Any car parts place has this, but be sure you get fuel hose not vacuum hose.
Could be a fuse, could be the fuel pump relay.
The fuel pump is located in the upper left corner in the trunk. The fuel pump is attached with 3 bults (i think it is a size 13)
First, release the fuel pressure in the system. Either unplug the wiring harness to the pump which is located under the foam padding by opening the rear hatch, lifting the foam up and locating the two wire plug toward the passenger seat or get a container and a big rag and disconnect a hose from the fuel filter located under the hood, passenger side. Jack up the rear of the car and install jack stands for support. The fuel pump is located on the passenger side above the wheel axel. If using a Nissan original pump replace in reverse of removal. If using auto parts store universal pump you will have to cut wires and add eye ends to fit new pump. VERY IMPORTANT to be sure to find '+' and '-' markings on the old pump and the new universal pump for correct attachment. If lucky enough to get the exact replacement the pump comes with the wire loom to reattach in the hatch area. Also, having just replaced my '79 280ZX pump with universal pump, they supply a brass fitting that screws onto the plastic end of the pump. This is about 1/2" in diameter, the other end is a banjo fitting much smaller that the 1/2" end. The hose size from the tank to the pump is about the 1/2" size where the hose from the pump to the engine is the smaller size. There was no marking on the pump as to the direction of flow, so the only answer is to attach the hoses as they fit the car.
Thermostat is located just below the water pump. Follow the lower radiator hose to the pump. There will be two bolts; likely size 8 bolts, and another nut just below attached to the hose to pull away from pump. Hope this helps!Thermostat is located just below the water pump. Follow the lower radiator hose to the pump. There will be two bolts; likely size 8 bolts, and another nut just below attached to the hose to pull away from pump. Hope this helps!
The fuel pump for the 1990 full size blazer is located inside of the fuel tank. If this model does not have an access plate in the floor of the blazer then the tank will have to be removed to get to the pump.
The fuel pump on a 1991 Nissan 240 SX is located back by the fuel tank. It is an in-line pump, in the fuel line that runs from the gas tank to the carburetor. It is about the same size as a large soup can.