It should be a number T15 or T20.
Yes. One switch is for the left and right brake light assemblies; and, the other is for the 'third' brake light.
a blown bulb or loose wire.
special bit for light lens cover, t 10 or t 20 bit light bulb unscrew from socket replace observe ligh light place foot on brake , re screw use brick on brake pedel
brake and abs light on , on 1994 Chevy Cavalier Z24
Should be a screw on either side - remove and cover should lift off
Most imports have a rubber plug in the brake pedal arm.It hits the brake light switch to turn it of.Look in the floorboard for pieces of rubber.If this piece came out,tou can put a flat screw in its place.If you use a screw you will need to un-screw the brake light switch 1-2 turns to adjust the switch so the brakes dont lock-up.
on your brake pedal lever.
THE BRAKE LIGHT SWITCH SHOULD BE BEHIND THE BRAKE PEDAL WITH A LITTLE PLUNGER OR IF NOT LOOK IN FRONT OF THE PEDAL THAT LOOKS LIKE A PLASTIC SCREW WITH 2 WIRE HARNESS GOING INTO IT. ITS A HEAD UNDER THE DASHS AND FEET ON THE SEAT NOT FUN. GOOD LUCK TYSON
there is a switch up under the brake pedal
On the brake pedal assembly.
There is no brake light relay. There is however a brake light switch located above the brake pedal.
If your brake light is on , either the parking brake is on or the BRAKE FLUID LEVEL in the brake master cylinder in your engine compartment IS LOW