Want this question answered?
go under the car with a 14mm spanner and undo the adjustment nut, also undo the nut that passes thru the clutch lever (sticks out the side of the gearbox) Slide the end of the cable out of the fork, and then remove the 14mm locking nut that holds the sheath of the cable in postition. This completes the 'clutch' size of the cable. Then using a 10mm spanner remove the 2 bolts/nuts in the engine bay where the clutch cable run into the cabin. In the drivers footwell stick your hand up and unhook the hook on the end of the cable off the top of the clutch pedal. Install is reverse of removal but requires you to tighten the clutch cable by tightening the nut on the clutch end of the cable. (you will know when you see it)
3/4 "
There is actually no specific formula used to work out cable size. In order to determine the type of cable you need and the size you need, you need to know the source of the supply, the voltage of the system, the ambient temperature, and the method you plan on laying out the cable.
Should be a T50
Yes, end of the cable on the clutch actuation arm on the gearbox located under the battery 10mm spanner size best wishes
HDMI ports are all the same size, but the size of the cord you need depends on how far the player is from your TV. It would be best to measure the distance before buying the actual cable
You need to know the amperage requirement of the pump and then you can calculate the wire size.
An extra heavy-duty galvanized steel cable.
35 KVA generator using for load 100 meter length which cable need to used
To answer this question the size of the cable or the amperage of the load is needed to calculate the correct wire size and connectors to fit the cable.
Use 6 gauge
I believe that is 4 OT.