go to auto parts store and get the right filter for the Saturn then go to the filter wrench selection and find one that fits that is the style you like
a wrench with a metal band that wraps around oil filter that ables you to turn aka an oil filter wrench
any oil filter wrench - it warps around the filter and you can adjust it - the wrench looks like a giant ring
In order to remove the oil filter from a 2007 Toyota RAV4 you need to use an oil filter wrench. This wrench is a specialty to Toyota.
You need a special wrench from your auto parts store.Slide the wrenchup into the fuel line on either side of the filter.You need to turn the wrench and push toward the filter on either side. The wrench pushes back mini clamps that grab the flange on each filter end.You do not need the wrench to replace the filter.
No..maybe a oil filter wrench to remove it, but, install it by hand (HAND TIGHT)
You need a 12 mm wrench, not Allen key.
You need a 9/16" box end wrench for the drain plug. The filter requires a special socket to remove the cap. I used to use a 1 1/4" open end wrench until I bought the socket from Snap-On.
No. 2008 highlander has a aluminum filter housing you need to remove with a special type of filter wrench. I was able to tap mine loose without a wrench but it could be at 24n-m tight which is difficult to loosen.
Just unscrew the filter. If you cannot remove it with your hands, it was put on too tight, which is common, as most people tighten them too much. You will need to use a good filter wrench. The type wrench you will need depends on how much room you have. Oil the gasket & Put the new filter back on and only tighten it 3/4 turn after the filter makes contact with the mounting surface. By doing this you will not need a filter wrench when removing the filter next time. 3/4 turn is plenty tight and any more is too much.Just unscrew the filter. If you cannot remove it with your hands, it was put on too tight, which is common, as most people tighten them too much. You will need to use a good filter wrench. The type wrench you will need depends on how much room you have. Oil the gasket & Put the new filter back on and only tighten it 3/4 turn after the filter makes contact with the mounting surface. By doing this you will not need a filter wrench when removing the filter next time. 3/4 turn is plenty tight and any more is too much.
You will need 5 quarts to change the oil and filter in a Saturn.
oil filter toolYou would need a oil filter wrench, a jack that's all you need to change the filter.
To change the oil filter on a 2008 2.4L Vue or Sky you need a special short 32mm (1.25in) socket with a 3/8 in drive. Here is a package that I found on eBay for the filter element and socket. Good luck! http://cgi.ebay.com/ebaymotors/GM-oil-filter-&-socket-wrench-32mm-Saturn-L-LS-LW-Vue-_W0QQitemZ120330902655QQcmdZViewItemQQimsxZ20081109?IMSfp=TL0811091110006r29122