Want this question answered?
What is the thread size for a Winchester Model 90?
Your Winchester model 25 rifle will take any size scope that you see fit to use as long as the rifle is drilled and tapped for scope use.If your rifle comes with a 3/8in.milled receiver rail then you must use that size scope ring bases.I recommend that a good 4X power scope is all that is needed for the effective range of .22cal rimfire ammo.
weaver refers to the type of scope mounts the scope uses. a weaver scope can mount on any rail size.
While anything is possible,why would you want to use a scope of that power and objective size on a .22 cal.rifle?If your receiver has a built in 3/8in receiver rail then you may be hard pressed to find rings of the significant height to mount a scope of that size.I would recommend that you get a scope of 4X power.That is all that is needed for the maximum affect range of a .22cal rifle.
Check the scope mount makers web sites or call Remington.
Would depend on the gun and size scope tube. The tube would be either 1" or 30mm. Could be side mount top mount etc...More info needed
Depends on the tube diameter and profile of your weapon.
The Winchester 140 12 gauge has a choke barrel at 28". This is the same choke size as the 20 gauge model.
2 3/4" & 3''
A Winchester model 1200 will hold 30 rounds. These rounds are similar to the size that a 12 gauge shotgun wold hold. This gun was first introduced in 1954.
Yes the stock on a Winchester Model 12 16 gauge is the same as a 20 gauge. 16 gauge,20 gauge, and 28 gauge are all the same for the Winchester Model 12. Thanks, Tim
The Model 77 Winchester will fire either long or long rifle cartridges. It is not chambered to fire short .22s cartridges.