0
It will be a metric size try different sizes until you find the one that fits.
Wiki User
∙ 11y ago
Add your answer:
Earn +20 pts
Bolt pattern for 1995 4Runner?
If your asking for the bolt pattern on the Toyota 4runner. It is a 6 on 5.5.
What is the bolt pattern on a Toyota 4Runner?
6*139.7
Does a 96 Toyota 4Runner and a 2006 Chevy trailblazer have the same bolt pattern?
NO....
Cylinder head bolt tightening sequence Toyota tercel 1.5?
head bolt sequence Toyota tercel
What socket is needed to remove 91 cavalier wheel cylinder bolts looks like reversed torx?
Any type of socket can be used to remove a 91' Cavalier wheel cylinder bolt that looks like a reversed torx. However, make sure the socket is a bolt head socket.
Will a 1991 Toyota sr5 4x4 transmission with a 6 cylinder fitin a 1989 Toyota xcab 4x4 4 cylinder?
It can fit if it is a manual 5speed and you swap out the v-6 bellhousing with a 22ret (22r turbo) bellhousing but good luck finding one they are hard to come by! No... only a 6 cylinder tranny will bolt to a 6 cylinder motor as same for a 4 cylinder tranny to a 4 cylinder motor but it can go in either a truck or 4runner.
Toyota 4Runner can you buy and install a 3.0 liter diesel engine for a 94 4runner 4x4 automatic Will it bolt up to existing mounts and trans for original 3.0?
sorry but no,the 22r version of the 4runner will work though
What is the torque for 1994 Toyota truck cylinder head bolt v6?
how much torque on a head bolt
Where is the transmission drain plug 1999 Toyota 4runner?
Follow the transmission dipstick which is located just below your right windshield wipers in the engine bay. You should see a pan with a 10mm bolt ref. to auto trans 1999 toyota 4runner
Cylinder head tightening sequence 1990 Toyota Cressida?
Pls let me know the cylinder head bolt tightening sequence for toyota cressida mx83
99 Toyota 4runner replace rear speed sensor rotor on the axle?
remove the 10mm bolt and remove it.disconnect plug at other end.
Will a 3.4 L engine from a Toyota T100 fit in a 1990 4runner?
If you have the 3.0L engine with a manual transmission it is a direct bolt up i dont know about the automatic but i am sure it is the same if you are switching from a four cylinder to the 3.4L then it requires a lot more work but it can be done a well
