30mm
7mm hex socket
I posted this question and have since replaced the bearings. Since an answer was not posted I will answer it myself. It's not too difficult. You need a 32mm Socket to remove the retaining nut. An inverted star socket(similar to a reverse torx wrench)is needed to remove the bolts holding the bearings in place(I think it takes a #16 inverted star bit). You also need a hub puller to remove the bearing assembly from the drive shaft. Good Luck!
What size Allen socket is needed to remove bolt from caliper on 2004 ford escape
you do not use a socket you use a wheel bearing puller to remove it from the hub Putting a right size socket into it and hitting it with a hammer can pop the bearing out, but it can also damage it so its advised to get the right tools. size 30 mm for the wheel nut and the bearing puller
9mm
special socket required to remove nut that retains rotor and wheel bearing. use impact gun . be prepared to repack and reset wheel bearing
You will need a 5/8 socket.
You will need a 35 mm socket.
For Axle Nut its 30mm
I used a 7mm hex bit socket. Worked fine, but the tool was a little hard to find. the 7mm hex key does not typically come in a L-key set.
You'll need a 5/8" socket.
9MM