0
What size socket to remove negative battery terminal on 2001 Ford?
Jimunderwood
I believe it a 1/2 " socket or wrench.
Wiki User
∙ 15y ago
Add your answer:
Earn +20 pts
How do you install a battery for a 2003 Mercury Mountaineer?
Using 8mm socket or wrench disconnect negative battery terminal first and then positive terminal. Then unbolt battery hold down located on side of battery near engine. Pull off plastic battery cover then remove battery. Clean battery terminals with wire brush. If bolts are corroded replace them. Replace battery, battery cover and hold down. Then put positive terminal on and then negative.
How do you disconnect the negative battery terminal on a 1995 Oldsmobile aurora?
The battery is located under the back seat. the back seat is removed by tuging firmly on the front side of the seat. the battery is side mounted so disconnect the negative battery terminal by unscrewing the bolt with an 8mm socket. other batterries may be an 9 or a 7mm.
How do you change the battery on a 1990 Ford Crown Victoria?
if it has the stock terminals, you need a 1/2" wrench. disconnect the terminals, starting with the negative (black). then, disconnect the red (positive). use a 10mm socket to remove the bracket that holds the battery down, and pull the battery out. put new battery in, put positive terminal on first, then negative, then put on bracket.
How do you uninstall battery of Pontiac Grand Am 2000?
Remove negative and positive cable using a boxed end wrench or socket. Remove the battery hold down clamps and then install the new battery reversing the procedure.
What is involved to changing a battery in 2001 S10 pickup?
Using a 5/16" 6 point box wrench or socket remove the negative battery cable first then the positive cable. Using a 13mm socket with a 10" extension remove the battery hold down bolt and remove clamp wedge. Remove the battery, clean up battery tray and cable ends with water and baking soda and wire brush. Install new battery, reinstall battery clamp and bolt. Attach positive battery cable first then negative cable. You will need to reset clock and radio settings.
Changing the battery on a 2006 BMW 330i?
The battery is located on the right side of the vehicle in the trunk. To view it, remove the right side panel where the factory tools are kept. Simply turn the black knob and pop out the plastic insert. Once you have exposed the battery, you will need a screwdriver and socket wrench to remove the arm bar and the battery terminals. Remove the negative terminal first. If you have navigation, your best bet is to have a certified tech do it for you. The computer has to be reprogramed after installation. After serious consideration, I decided not to replace the battery myself.
How do you remove the battery from a 2007 vw beetle?
How do you remove the battery from a 2007 vw beetle? Need: 10 mm wrench or socket 6 mm hex socket and extension ratchet The battery is located to the far right as you face the engine bay. You need to remove the battery cover. It has several obvious plastic tab latches that you push to release. Remove the cover. You will see a breaker box on top of the battery. This slides out pushing away from you towards the back of the car. Remove the positive and negative battery terminals with a 10 mm socket or wrench. Bungee cord or duct tape the whole collection of breaker box and positive and negative terminal away from you, clear of the top of the battery. You will see that the battery is surrounded and partially covered by a plastic shield. The left front side releases by pushing on obvious plastic tabs to the right. The shield will seem to be stuck in the center back. There is no tab to release here, it is a friction fit (this is the secret!). Pull straight up on the shield and it will release. Voila! You just completed the hard part. Almost there! Center front at the base of the battery is a 6 mm hex bolt holding the battery in. You will need a socket extension and a hex socket to remove this. Once this is removed, slide the battery to the left and tip it up and out.
What tool do you use to take out battery?
The correct size socket and ratchet to remove the hold down. And the correct size socket to remove the battery cable clamp.
How do you remove the battery of a 2009 Harley Sportster?
Using an 11mm socket on a universal (wobbly) joint remove the nut that attaches the earth strap to the engine block.This is located on the right rear of the engine hiding behind the oil pipes. Next remove the left hand side panel,undo the nut that fixes the battery retaining strap and then move the strap clear of the battery. Remove the 10mm positive battery terminal nut behind the red cover and you should now be able to pull the battery straight out taking the negative strap with it.
How do you replace a battery in a 2001 vw golf?
This is fairly easy... however: DISCONNECT NEGATIVE TERMINAL FIRST!! # Make sure your car is off # Keep your oem head unit codes handy in case you need to reset it # Disconnect you're negative terminal (use a rubber coated socket wrench to loosen the screw holding it in, make sure you wrap it in a rag to avoid it touching any ground on your car, and tape it off or hold it somewhere) # Disconnect the positive terminal # Reconnect your positive terminal # Reconnect your negative terminal # Then secure your battery covers and start your car and you're done!!
How do you disconnect the battery on a 2002 Beetle?
This is fairly easy... however: DISCONNECT NEGATIVE TERMINAL FIRST!! # Make sure your car is off # Keep your oem head unit codes handy in case you need to reset it # Disconnect you're negative terminal (use a rubber coated socket wrench to loosen the screw holding it in, make sure you wrap it in a rag to avoid it touching any ground on your car, and tape it off or hold it somewhere) # Disconnect the positive terminal # Reconnect your positive terminal # Reconnect your negative terminal # Then secure your battery covers and start your car and you're done!!
How do you remove battery in 2005 Dodge Caravan?
there is a clamp holding the battery in place.Use a socket wrench and remove it.Disconnect the negative line first make sure it does not touch anything.Disconnect the positive(again don't let it touch anything), lift the old battery out.Install is the reverse
