0
What size speaker came factory in a 98 eclipse spyder door panel?
Wiki User
∙ 15y ago
according to "crutchfield" Factory replacement info: : In-dash stereo : 8-11/16" depth; Size code E,S,U : Front speakers : Dash: 4" : Front Door: 6-3/4" : Far rear speakers : Rear Seat Side Panels: 6x9"
Wiki User
∙ 15y ago
Add your answer:
Earn +20 pts
Where is the turn signal flasher unit on a 1997 Mitsubishi eclipse spyder?
Behind A/C and heater control panel, in center console.
What is the reset mechanism for Mitubishi Eclipse Spyder top that has lost power?
what year? the 1998 model has a "manual mode" switch inside the left side panel in the trunk.
How do you remove rear speakers in a 2002 voltswagon bug?
You must remove the rear interior panel by lifting on the rear, and pushing the panel forward. Once done, the speaker is behind the panel, bolted to the sheetmetal frame with 4 bolts. You will need a Speaker Adapter to mount an aftermarket 6.5" speaker. Or you may use a factory replacement speaker. The adapter that I found was a Scosche SAVW6.
How do you remove the rear speakers in a 2003 Mitsubishi eclipse?
You need to remove the rear seat and the panel covering the speaker. Before removing the panel make sure that you have removed all screws. Pay attention to the clips holding the panel as well.
What is the factory speaker size in a 1988 Blazer?
The full size blazer has 5.25 in the kick panel and 4 x 10's in the rear.
Where are the factory amps located in a 94 Nissan Pathfinder?
Behind the rear cargo panel on the passenger side. If you have a 4 speaker system there will be one. If you have a 6 or 8 speaker system there will be 2. Hope this helps
Where is the factory Bose amplifier located in a 97 Nissan maxima?
Amps for the factory Bose system of a 97 nissan maxima are located in passenger door panel for the front and in the speaker casing in the trunk for the rear.
What size are the speakers for a 2001 Mitsubishi Eclipse Spyder GT and how do i remove the door covers to install new speakers?
the covers do not pop off. you have to take off the entire side panel. im not sure but they are probobly 6 x9's.
How do you change door speakers?
Open The Door, Remove The Door Panel, Remove Speaker, Wire The New Speaker, Fix The Speaker To The Door, Refix Door Panel, Switch On
How do you remove-replace stereo speaker in '99 Durango?
Remove the door panel screws (outer edges). Remove the door pull screws. Roll down window. Apply slight pressure to bottom of door panel by squating and placing knees under the door panel and raising up on toes to apply the pressure up and out. This will release the tabs holding bottom portion of door panel on. **There is also a tab by the door pull take care not to break**. Once bottom of door panel is released push in at top of door panel work top of door panel up at window opening until removed. May also need to remove or peel back sound barrier (the black adhesive is extremly sticky, worse when hot) Once door panel is removed, remove the screws holding the speaker/mounting spacer in. Detach the tabbed connector from the speaker. If using an after market speaker mounting spacer may need to be modified to accept speaker. Connector may be removed from old speaker and soldered onto the new speaker to retain factory connection. Install new speaker and replace door panel.
How do you replace speakers on a 2000 silverado?
For a 2000 Chevy Silverado Ext Cab 4 dr 4x4 Z71 Front 6.5/6.75 inch speaker remove door panel and then install new speaker reattach panel. Rear 4x6 inch speaker remove rear door panel and install new speaker reattach panel.
Do you take the door panel off 1998 mercury mountaineer to replace speaker?
Yes, the door panel needs to come off to replace the speaker.
