0
Remove the door panel screws (outer edges). Remove the door pull screws. Roll down window. Apply slight pressure to bottom of door panel by squating and placing knees under the door panel and raising up on toes to apply the pressure up and out. This will release the tabs holding bottom portion of door panel on. **There is also a tab by the door pull take care not to break**. Once bottom of door panel is released push in at top of door panel work top of door panel up at window opening until removed. May also need to remove or peel back sound barrier (the black adhesive is extremly sticky, worse when hot) Once door panel is removed, remove the screws holding the speaker/mounting spacer in. Detach the tabbed connector from the speaker. If using an after market speaker mounting spacer may need to be modified to accept speaker. Connector may be removed from old speaker and soldered onto the new speaker to retain factory connection. Install new speaker and replace door panel.
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
Where is the heater control valve located on a 99 durango?
99 Durango doesn't have a Heater Control Valve, It only has a thermostat
What is a synonym for 'lemon'?
'99 Durango
Where do you put the transmissin fluid in a 99 dodge Durango Durango?
in the dipstick hole.
Does my 99 Dodge Durango have a cabin filter?
No.
99 durango 5.9 horsepower?
245 horsepower
Where is the location of a gps sensor 99 Dodge Durango?
A 1999 Durango does not have any part called a GPS sensor.
Are there cabin air filters in 99 Dodge Durango's?
no, not from the factory
How do you check the codes on a 99 Dodge Durango?
With a scan tool,
Is a 99 durango and a 92 Dakota interchangable on fuel pumps?
No
Where is the tcc solenoid on 99 Dodge Durango?
in side the transmission
How do you change a fuel filter on 99 durango?
The fuel filter is part of the Fuel pump assembly, located in the gas tank of the '99 Durango. It cannot be changed independently of the fuel pump.
What are the wire colors for 99 intrepid with the infinity stereo?
The wire color codes for a 1999 Dodge Intrepid with the infinity stereo are simple to follow and identify. The car radio constant 12V+ wire is pink, the radio switched 12V+ wire is red/white, the radio ground wire is a black strap, the stereo dimmer wire is orange, and the stereo antenna trigger wire is orange/red. For the front speakers, the left front speaker wire (+) is dark green, the left front speaker wire (-) brown/red, the right front speaker wire (+) is purple, and the right front speaker wire (-) is dark blue/red. For the rear speakers, the left rear speaker wire (+) is brown/yellow, the left rear speaker wire (-) is brown/light blue, the right rear speaker wire (+) is dark blue/white, and the rear right speaker wire (-) is dark blue/orange.
