If it's a 1/2 ton it will be the 4L60E transmission. 3/4 tons used the 4L80E in them.
Yes it will, As long as both trucks are either a 1/2 ton or a 3/4 ton, 4-wheel drive are just a 2-wheel drive.
Left rear of the transmission on 2 wheel drive trucks.
This car (the four-wheel drive is optional) has four-speed, electronically controlled OD transmission.
If it's a 2-wheel drive, Then it is screewed into the transmission tail shaft housing where the driveshaft goes into the transmission. If it's a 4-wheel drive then it will be screewed into the transfur case.
It is bolted to the rear of the transmission. Both driveshafts connect to it.
4l60 or a 4l80
If it is a 1/2 ton then it will have the 4L60E in it. The 3/4 tons used the 4L80E in them.
Yes as long as the 95 is a 4L60E also. Remember that a 2-wheel and a 4-wheel drive transmission will NOT interchange.
Yes it will fit right in there no problems. As long as they are both 2 wheel drive or they are both 4 wheel drive. Can not mix them up.
Just Drive It
yes but you would have to replace drive shafts. The 4x4 shaft is shorter due to the transfer case.
You will have to get a 4L60E 2-wheel drive transmission and put in it. You will also have to get a driveshaft made for it too. You will also have to remove the front driveshaft.