Champion DJ7Y (gap of 0.025")
Champion DJ7Y. Not sure of the plug gap though.
there are a lot of homelite machines out there weed eater chainsaws you didnt tell us what it is but i can tell you the best thing to do is go to your nearest dealer tell them what it is they can get you a plug.you can also call to save on costly gas.
If you mean that the wire came out of the boot, then pull the boot off of the spark plug and use a spark plug socket to remove the spark plug.
Remove the spark plug wires from the spark plugs, use an extension for your Allen wrench, and use a spark plug socket to remove the spark plug.
The best way is to use the spark plug socket out of the factory tool kit. If you do not have that use a normal 5/8" socket to loosen the spark plug. Use the spark plug wire to snap back on after the plug is loose and pull it out. The spark plug is at the very top of the engine, the spark plug wire is a real good indicator of its location.
use the spark plug wrench and use used mirror to find the rear spark plug, you need to two person to do this, then fell the spark plug rear with your hands then apply the spark wrench to remove the old spark plug.
.044 is the spec, i suggest use KNG spark plug brand .044 is the spec, i suggest use KNG spark plug brand
you must take the top module off the engine and then remove the rubber plugs that are on top of the spark plug, then use the spark plug sockets to get them out you must take the top module off the engine and then remove the rubber plugs that are on top of the spark plug, then use the spark plug sockets to get them out you must take the top module off the engine and then remove the rubber plugs that are on top of the spark plug, then use the spark plug sockets to get them out
Remove the spark plug wire from the spark plug. Use some heavy gloves or a set of insulated pliers to hold the spark plug wire about 1/4-inch from the engine block (ground) and crank the engine - you should see a spark jump from the wire to the engine ground. For a better check, use another spark plug and put it on the spark plug wire and use it as a "jumper" from the wire to the engine ground.
Just immerse the spark plug in a recipient with solvent, kerosene or thinner, and use a hair dryer to get the spark plug dried again.
Use a .5 feeler gauge for the TR Spark Plug Gap.
you can just use a j4c without a resistor